AFFILIATE DISCLOSURESpecForgePC is reader-supported. As an Amazon Associate, we earn from qualifying purchases. Learn more →
RAM & SSD UpgradesUpdated 2026-10-28 · 7 min read

MSI Katana 15 HX RAM & SSD Upgrade Guide: Dual M.2 PCIe Gen5 & 64GB DDR5

A technical upgrade tutorial for the MSI Katana 15 HX B14W. We detail the dual SO-DIMM DDR5 slots, PCIe Gen5 M.2 primary slot, open secondary drive bay, and safety steps.

SF
SpecForgePC Documentation TeamManufacturer-Documented Hardware Analysis

As an Amazon Associate, we earn from qualifying purchases.

Quick Answer

The MSI Katana 15 HX B14W features outstanding modular upgradeability. It houses two accessible DDR5 SO-DIMM memory slots supporting up to 64GB or 96GB of DDR5-5600 RAM, along with two M.2 2280 NVMe SSD slots. Slot 1 is PCIe Gen5 x4 compatible, while Slot 2 supports PCIe Gen4 x4. You can easily add a second NVMe SSD without touching the pre-installed Windows operating system drive.

Key Hardware Takeaways

  • Dual Modular DDR5 SO-DIMM Slots: Neither RAM module is soldered. Both slots can be accessed after removing the bottom cover to upgrade system memory up to 64GB (2x 32GB) or 96GB (2x 48GB).
  • PCIe Gen5 x4 Storage Architecture: The primary M.2 slot supports Gen5 NVMe solid-state storage with read speeds exceeding 10,000 MB/s.
  • Open Secondary M.2 2280 Slot: The second M.2 PCIe Gen4 slot is empty from the factory on standard configurations, allowing instant capacity expansion without OS cloning.
  • Cooler Boost 5 Clearance: Heat pipes cover the CPU and GPU zones, while memory and storage slots remain directly accessible once the chassis panel is detached.

Upgradeability Assessment & Slot Specifications

This guide is based on official maintenance documentation and technical specifications from MSI checked on October 28, 2026. We did not physically test this laptop. Learn about our research methodology.

Upgradeability Verdict: Fully Upgradable (2x SO-DIMM, 2x M.2 NVMe)

Official Specification: Supports up to 64GB / 96GB DDR5-5600 memory across two SO-DIMM slots and up to two M.2 2280 NVMe SSDs (one PCIe Gen5 x4 compatible, one PCIe Gen4 x4). Per official MSI documentation.

Subsystem Factory Configuration Maximum Tested Limit Slot Standard & Notes
Memory (RAM) 32GB DDR5-5600 (2x 16GB) 64GB (2x 32GB) or 96GB (2x 48GB) 2x standard DDR5 262-pin SO-DIMM slots
Storage (SSD) 1TB PCIe Gen4 M.2 2280 Up to 4TB+ per slot Slot 1: PCIe Gen5 x4; Slot 2: PCIe Gen4 x4

Safety Notice & Step-by-Step Installation Procedure

Important Safety Notice: Always shut down the system completely, disconnect the AC charger, and ground yourself before handling sensitive electronics. Disconnect the internal battery connector from the motherboard immediately upon opening the bottom cover to prevent electrical short circuits.

Before Ordering Components:

  • Confirm your model code (B14WGK / Katana 15 HX) on the bottom chassis label.
  • Prepare a Phillips #00 precision screwdriver and a plastic pry tool (spudger).
  • Back up your important personal files before opening hardware panels.
  1. Chassis Screw Removal: Place the laptop upside down on a clean, non-abrasive mat. Remove the Phillips screws securing the bottom panel. Note that screw lengths may vary, so keep them organized in their original locations.
  2. Prying the Bottom Panel: Insert a plastic spudger along the seam near the rear exhaust vents. Gently pop the plastic retaining clips around the perimeter until the bottom panel lifts away cleanly.
  3. Battery Disconnection: Locate the 75Wh battery at the bottom of the chassis. Disconnect the multi-pin battery cable from the motherboard connector before touching any RAM or SSD slots.
  4. Installing Secondary M.2 SSD: Locate the empty M.2 slot adjacent to the pre-installed drive. Remove the retaining screw, insert your secondary M.2 2280 NVMe SSD at a 30-degree angle into the slot, press it down flush, and secure it with the retaining screw.
  5. Upgrading Memory Modules: To replace RAM, gently push outward on the metal retaining clips on each side of the SO-DIMM slot until the module tilts upward. Slide the module out and insert the new DDR5 module firmly at an angle before pushing it down until the clips lock into place.
  6. Reassembly: Reconnect the internal battery cable, align the bottom cover, snap the perimeter clips back into place, and reinstall the exterior screws.
Check price on Amazon

Frequently Asked Questions

Can you upgrade the RAM on the MSI Katana 15 HX yourself?

Yes. The MSI Katana 15 HX features two modular DDR5 SO-DIMM slots accessible by removing the bottom chassis panel, supporting up to 64GB or 96GB of memory.

Does the MSI Katana 15 HX have a second SSD slot?

Yes. The laptop includes two M.2 2280 NVMe SSD slots. The secondary slot is open out of the box, allowing you to add storage without cloning or replacing the Windows operating system drive.

Does the primary SSD slot support PCIe Gen5?

Yes. According to MSI specifications, the primary M.2 slot supports PCIe Gen5 x4 NVMe solid-state drives, offering bandwidth for ultra-fast storage.

Documented Primary Sources

This guide is based on the following documentation: